24v Power Supply (16.5A, 400W)

  • 4
  • Product Code: E-PSU-24V-400W
  • Product viewed: 2741
  • $54.99 CAD


Power supply for 3D Printers. 


DC output voltage12v24v
DC output current33A16.5A
DC output voltage error±1%±1%
Ripple and noise150mV150mV
Input current6.5A/115V 4A/230V6.5A/115V 4A/230V
AC input voltage range85-132VAC/170-264vac 47-63HZ 240-370VDC85-132VAC/170-264vac 47-63HZ 240-370VDC
Over load protection105-135% cut off the output auto -recovery105-135% cut off the output auto -recovery
Over-voltage protection115-135 cut off the output auto -recovery115-135 cut off the output auto -recovery


There is a voltage-selector switch so configure the PSU to match your national supply voltage which must be checked and set upon receipt of the supply. The default setting is 220v which is less likely to cause damage if plugged into a 110v supply, however the reverse may cause irreversible damage. 

Friendly advice

This part is aimed at experienced users, if you are not comfortable wiring in your own mains then please consider an alternative supply. All terminals must be insluated to avoid short-circuit and risk of electrocution to anyone that may be exposed to your printer. Please play safe!

Write a review

Note: HTML is not translated!
    Bad           Good